Firmware & Updates

Choose Product Model

Firmware Release Notes

Released date
Firmware Version
Download
2023.09.26
1.1.5.3
2024.09.19
1.1.5.4

Details

  • 1.1.5.4：Add PSTI verification(Password modification needed when login with APP or browser based software)

Upgrade Tutorial for: HUB

Important Precautions (Before You Start)

  • ⚠️Upgrade may cause unknown errors. Avoid upgrading when you need to use it.
  • ⚠️Maintain sufficient power during the upgrade process.
  • ⚠️Do not pull out the USB flash drive before the upgrade is successful.
  • After the device is upgraded, the default settings are restored.

Required Upgrade Tool

  1. A computer with Windows 10 or Mac OS 12.6 system (or later).
  2. A USB flash drive with 32GB or less of storage, formatted as FAT32.
  3. USB-A to USB-C cable.

Upgrade Steps

Upgrade By USB Disk

Step 1
Prepare one USB disk which memory less than 32G, and format it to FAT32.
Step 2
Check the base station hardware version from version info page (H000, H001 or H002). download the upgrade files from the link and select the corresponding upgrade file, and then put it to the root directory of the USB flash.
Step 3
Connect the USB disk to the base station, and the device will start the upgrade automatically, after upgrade successful, the base station will reboot automatically.
Step 4
Connect the belt pack to the base station one by one, and the belt pack will be recognized for upgrade.

Upgrade By Browser Based software

Step 1

Check the base station hardware version from version info page(H000, H001 or H002)，and then connect the base station via WiFi or LAN
Connecting to the base station via Wi-Fi
  • Turn on the Wi-Fi under the network settings on the Solidcom M1 front panel.
  • Connect the base station to a laptop via Wi-Fi with the default password 12345678.
  • Open a browser, enter the IP address 192.168.217.100, and then log in to the web page(User:admin Password:12345678).
Connecting to the base station via LAN
  • Turn off the DHCP under the network settings on the Solidcom M1 front panel and check the base station IP address (default: 192.168.218.10).
  • Connect the base station to a laptop via the LAN port with an Ethernet cable.
  • Set up the IP address of the laptop and make sure the IP address is in the same network section as the base station such as 192.168.218.25.
  • Open a browser, enter the IP address of the base station, and then log in to the web page(User:admin Password:12345678).

Step 2

Switch to "settings" page, and then go to "firmware upgrade " and select the corresponding upgrade file, and the device will start the upgrade automatically, after upgrade successful, the base station will reboot automatically.

Step 3

Connect the belt pack to the base station one by one, and the belt pack will be recognized for upgrade.